Topcon HiPer II, Руководство оператора

Страница: 27 / 140

Principles of Operation
P/N 7010-0982
1-13
To Insert the Battery:
1. Remove the battery cover.
2. Gently slide the bottom of the battery along the battery guides
until it snaps into place (Figure 1-5 on page 1-13).
Figure 1-5. Remove Battery Compartment Cover
Charging the Battery
To charge the battery, use the included charger. It takes
approximately 4 hours to completely charge one battery, and 8 hours
to completely charge two batteries.
The Li-Ion batteries used in the battery packs should run at no less
than 80% capacity after 500 charging cycles. These batteries do not
need to be drained before recharging.
It takes approximately 4 hours to completely charge one battery, and
8 hours to charge two batteries using the included CDC68 charger.
NOTE
The battery is shipped from the factory without
power. Fully charge the Battery before surveying.
Slide Battery
to the Left to
Lock in Place
HiPerII_OM.book Page 13 Wednesday, December 15, 2010 9:07 AM