FINISH CONSTRUCTION
HOOK UP THE THROTTLE
❏
1. Mount your engine mount and engine to the
firewall. Mount your muffler to make sure your throttle
pushrod will not interfere.
This is the throttle servo location for fixed gear.
This is the throttle servo location for retractable gear.
❏
2. Place your throttle servo tray on the rails.
Position the throttle servo in the tray. Connect the
.074” x 17-1/2”
throttle pushrod
to your servo with a
small, brass
Screw-Lock connector
. Connect the
other end of the throttle pushrod to the engine with a
nylon
ball socket,
0-80
threaded ball
and 0-80
nut
.
Use a drop of thread lock on the nut. Glue the throttle
servo tray to the rails. Secure the throttle servo to the
tray with the hardware that came with the servo.
❏
R2. Install a 0-80 threaded ball link ball (not
included) onto the arm on both sides of the nose
wheel strut with a 0-80 nut. Connect the other end
of both cables to the threaded ball links with the
swages. Tighten the loop in the cable just enough
so it will not come off the ball. Crimp the swages.
Temporarily hook up the steering servo to your
radio system and test the movement. Adjust the
tension on the cables or make other adjustments
if needed.
Note:
If your nose gear steering arms did not
come bent 90 degrees as shown, do so now.
-49-
Содержание T-34B MENTOR
Страница 7: ...7 DIE CUT PATTERNS...
