TOHATSU BFT 250A, Руководство по обслуживанию

Страница: 579 / 639

19-17
dummyhead dummyhead
TRIM/TILT
Apply marine grease to the circumference of the swivel
case liner [1], swivel case [2] thrust receiver part and
shaft sliding part.
Install the swivel case liner by aligning the projection [3]
on the swivel case liner with the groove [4] in the swivel
case.
Apply marine grease to the thrust washer (34 mm) [5],
new oil seal (39.5 x 52 x 6 mm) [6] lip and outer surface,
wave washer (40 mm) [7], and mount frame [8] shaft
and spline, and then install them to the swivel case.
Apply marine grease to the spline of the lower mount
center housing [1] spline.
If the original lower mount center housing is reused,
install the lower mount center housing on the mount
frame by aligning the " " mark [2] on the lower mount
center housing with the mark [3] on the mount frame
during disassembly.
[8]
[2]
[6]
[7]
[5]
[2]
[1]
[3]
[4]
[1]
[1]
[1]
[3]
[2]