Toa VP-2241, Инструкция по эксплуатации

Страница: 209 / 328

Chapter 8: INSTALLATION AND SETTING PROCEDURES (HARDWARE)
3. VX-2000Sf, VX-200SZ , VX-200SP, VX-200SI , VX-200SO, AND VX-200SE
8-31
3.5. Changing the VX-200SI's Logic
The logic ("make" or "break" signal activation) of the cTrl IN terminal can be changed by the DIP switch on
the VX-200SI circuit board.
SW100: used to switch the logic of cTrl IN terminals 1 – 8.
Switches 1 – 8 correspond to cTrl IN terminals 1 – 8.
SW101: used to switch the logic of cTrl IN terminals 9 – 16.
Switches 1 – 8 correspond to cTrl IN terminals 9 – 16.
• The logic can be individually changed for each of CTRL IN terminals 1 – 16. To change, set the switch
corresponding to the desired cTrl IN terminal to the m (make) or B (Break) side.
• All switches are factory-preset to the M (Make) side.
[Logic change switch position]
VX-200SI
M
B
SW101 SW100
M
B
1 2
ON
3 4 5 6 7 8
M (Make)
B (Break)
SW100
1 2
ON
3 4 5 6 7 8
M (Make)
B (Break)
SW101