Toa VP-2241, Инструкция по эксплуатации

Страница: 155 / 328

Chapter 7: PC SOFTWARE OFFLINE SETTINGS
9. OPErATION SETTING mODE
7-40
Step 1. Select the control output to be activated in emergency situations.
• Double-click on the leftmost blue area of the control output list, causing a tick to appear in the selected
area.
• Clicking on the [Select ALL] button will cause ticks to appear for all control outputs.
• Clicking on the [Clear ALL] button will cause all ticks to disappear from all control outputs.
Step 2. click on the [Apply] button after setting completion to save the settings and click on the [OK] button to
close the [Emergency Settings] window.
Note
When no EV units are used, sequence setting and emergency broadcast pattern setting cannot be performed.
Whichever the [Post Emergency microphone Operation] is set for "continue" or "Silent," broadcast is terminated
after the fireman's microphone announcement because there is no basic EV broadcast.
9.1.2. When using a single EV unit
The [Emergency Settings] window opens, permitting up to 50 emergency broadcast patterns to be created and
used.
Step 1. Set the [Post Emergency microphone Operation].
• [Continue]: The original EV broadcast to the designated zone(s) is restored after completion of the
fireman's microphone announcement.
• [Silent]: The original EV broadcast is not restored after completion of the Fireman's Microphone
announcement.
Step 2. Set the [Emergency Sequence].
2-1. Select either the "Alert" or "Evacuation" message for Phase 1 EV message.
2-2. Select the message broadcast duration for Phase 1 (1 – 20 minutes in 1-minute increments or
continuous).
2-3. Select either the "Alert" or "Evacuation" message for Phase 2 EV message.
Note: If the broadcast duration for Phase 1 is set for "continuous," Phase 2 cannot be set.
Continued on next page