USER MANUAL SAGA
Page 25 of 47
The Docking Station of the SAGA system
(1)
can be connected to a PC
(2)
via a
USB cable and via an Ethernet cable
(3)
. Both connections are used for control of
the device
(4)
and data transfer to the PC where it can be stored for further
processing
(5)
. It is also used for sending commands from the application software
to the SAGA system to control the device (start/stop, configuration updates etc.).
Software
System requirements
Computer requirements
Supported Operating
systems
•
Windows 10 (64 bit)
•
Windows 7 SP1 (64 bit)
Available ports
•
USB port (2.0 or higher)
•
(Optional) Ethernet port (>100 Mbit)
Hard drive
•
200 GB available (for storage of measurement data)
Driver installation
The latest version of the driver can be downloaded from
the USB stick that came with the device. Run
the
TMSi SAGA Device Driver Setup x64.exe
and follow the steps on screen.
Application Software
TMSi Polybench
TMSi Polybench is software that is commercially available through TMSi. TMSi
Polybench can be used for experimenting with different configurations and customer
specific applications. TMSi Polybench is the framework on which the SAGA Quick
Recording Application was built. TMSi Polybench is software that is intended for
research purposes only and may not be used for diagnosis or treatment.
The Quick Recording Application (QRA) can be used to do recordings with the SAGA
system. The QRA can also be used to configure the SAGA Data Recorder.
TMSi Interface for MATLAB
TMSi has developed an interface to MATLAB (
). The interface
can be downloaded free of charge on the TMSi website. TMSi does not sell or
distribute MathWorks products, nor supports them.
