USER MANUAL SAGA
Page 23 of 47
Station and the gutters on the bottom of the Data Recorder. See illustrations below.
The wired connection indicator in the status indicator windows will light up green
when the connection is made correctly.
1. The arrows on the Docking Station indicate the direction for docking the Data
Recorder and the alignment point for the docking rail of the Docking Station.
2. Make sure the Data Recorder is aligned properly and slide it gently onto the
Docking Station.
3. Push forward until the Docking Station and Data Recorder are perfectly
aligned on top of each other and you cannot push any further.
You may dock the Data Recorder on the Docking Station while recording. This may
cause artefacts in the signals. In order to minimize artefacts, gently slide the Data
Recorder on the Docking Station.
To undock the Data Recorder from the Docking Station, push the Data Recorder in
the opposite direction. Depending on the device configuration a Wi-Fi connection will
be established. If you did not configure the device for wireless operation, the
connection between Data Recorder and Docking Station is now interrupted.
Connect accessories
The connectors for subject accessories, except the Patient Ground and Common
Reference described in this section are all provided with a ‘Push-Pull’ mechanism,
to prevent them from getting detached inadvertently. This means that each
connector plug is provided with a sleeve part that slides a bit along the axis of the
plug to operate a retention mechanism. To make a connection, observe the
alignment symbols and gently push the plug into the receptacle of the SAGA device.
To disconnect, take hold of the plug at its moving sleeve, the part closest to the
socket, and gently pull the plug out. Do NOT pull at the accessory wire or at the wire
end of the plug.
