USER MANUAL SAGA
Page 21 of 47
4
INSTRUCTIONS FOR USE
Power the Docking Station
Plug the mains power plug into a well-earthed mains socket and connect the power
adapter connector to the Docking Station. Make sure you use the correct orientation.
When you insert the connector, you will hear a ‘
click’
. Once connected to mains, the
Docking Station automatically powers up, indicated by the power light on the back
and after a start-up period, the power indicator in the status indicator window signals
that the Docking Station is fully operational.
The Docking Station can be powered down by unplugging the mains power
connector.
Power the Data Recorder
The Data Recorder is either powered by batteries or by mains via the Docking
Station. The latter only when the Data Recorder is docked on the Docking Station.
Insert or remove batteries
Batteries can be exchanged by opening the battery compartments:
1. Press the orange release button (see 1 in figure below).
2. The compartment door will open enough to grab it with a finger; now you
can pull it open (see 2 in figure below).
3. Slide in the battery,
with battery contacts first and oriented to the left
.
For further instructions, refer to the Quick Guide in the inlet of the suitcase.
4. Close the battery compartment door, until you hear and feel that it locks.
Briefly press the On/Off button to power on the Data Recorder. When the
device is not acquiring data, the ON/OFF button also powers down the Data
Recorder. During a measurement, the Data Recorder will not power down
by means of the ON/OFF button.
