Titgemeyer TIOS ER15, Руководство по эксплуатации, Страница: 8 / 28

8
Phone: +49 (0)5 41/58 22-0 Fax: +49 (0)5 41/58 22-491 E-mail: fasteners@titgemeyer.com
L
Tb1524GB(1212)1
TIOS
®
ER15 Battery-Operated Blind Rivet Tool
Operating Instructions
Safety notes
(continued from Page 7)
• For safety reasons, the lithium-ion battery should not be left in an active
charger for longer than 36 hours.
Whenever possible, remove the battery from the
charger as soon as it is fully charged.
• Whenever possible, always remove the battery from the device before trans-
porting.
This will prevent you from unintentionally switching the device on and also pre-
vent the battery from running down very low.
• Never expose the lithium-ion battery to high temperatures (+ 50 °C) or direct
sunlight.
If the battery becomes hotter than 50 °C while in operation (charging or dis-
charging), immediately remove it from the charger or rivet tool.
• Keep unused batteries away from paper clips, coins, keys, nails, screws and
any other small metal objects that might bridge/short-circuit the contacts.
Never open or short-circuit the battery.
Short-circuiting the battery contacts may
result in burns, fire or explosions.
• Batteries may leak when subjected to extreme use or temperatures. Keep your
skin and eyes away from a leaking battery at all times. The liquid contained in a battery is
corrosive and may cause chemical burns in human tissue. Should the liquid come into
contact with the skin, immediately wash it off with soap and water and then with lemon juice
or vinegar. If the liquid comes into contact with the eyes, rinse with water for 10 minutes and
then seek the advice of a doctor immediately.
• Never charge the battery in temperatures BELOW 10 °C or ABOVE 40 °C.
• The charger must never be connected to a step-up transformer, generator or DC socket.
• Ensure that the ventilation slots on the charger are never covered or clogged.
• Never store the electrical tool or battery in areas where temperatures exceed 50 °C.
• Never store the battery in a box or enclosed container. The battery must be stored in a
well-ventilated area.
• No changes, modifications or alterations may be made to the tool without the manufacturer's
permission. No conversions may be performed without first being approved in writing by
Gebr. Titgemeyer GmbH & Co. KG. Any parts not in fully-working order must be replaced
without delay.