Titgemeyer TIOS ER15, Руководство по эксплуатации

Страница: 14 / 28

14
Phone: +49 (0)5 41/58 22-0 Fax: +49 (0)5 41/58 22-491 E-mail: fasteners@titgemeyer.com
L
Tb1524GB(1212)1
TIOS
®
ER15 Battery-Operated Blind Rivet Tool
Operating Instructions
Initial setup
Application-pressure
control
Mandrel container
Charging battery
Description of LED status
on the charger
1. Read the operating instructions and keep in a safe place.
2. Perform a visual inspection of the devices to check for defective or loose parts
(damage in transit).
3. Plug the charger to the mains.
4. Insert the battery into the charger (check the display!).
5. Charge the battery (approx. 60 min).
6. Attach the spent mandrel container. To do this, rotate the container about a quarter turn.
Empty the container and then reattach as and when required.
7. Insert the battery into the rivet tool until you hear an audible “click”. (To remove the battery,
press the catch downwards and pull the battery forwards).
8. Press the start trigger.
9. The rivet tool is now ready for use.
• Note:
The tool is operated by means of application-pressure control. Apply a little pressure to the
pulling unit until it moves slightly. Now press the start trigger.
• Note:
A magnetic contact switch is installed on the mandrel container. If the container has not
been fitted or if the contact is not closed, the tool will not operate.
Left LED
Preparing and fitting the rivet tool
Right LED
Battery charged
Defective battery
Battery too hot
or too cold
Charging battery
Mains
Defective
charger