TTB892MLT
Getting
started...
EN
Before you start
25
NOTE:
Adjust the scraper (12) and plunge saw blade (8/10) at the
desired angle according to the intended use. The tool holder (6) and
at 30° intervals around the tool holder, from -90° to +90°.
> Follow the same procedure for “adjusting of sanding base plate”.
Removing/Replacing
NOTE:
Replace the tool attachment if it is worn or shows damage.
Never use a tool attachment which is damaged or worn in order to
avoid hazards and resulting injuries and damages.
> The tool attachment can be removed following the reverse actions as instructed
for “attaching”.
> Check for damages and wear, clean the tool holder from dust and attach a new
one if necessary.
-90°
+90°
-90°
0°
Fig. 7
0°
Fig. 8
Fig. 9
+90°
