TTB892MLT
Before you start
Getting
started...
EN
24
Sanding base plate/paper
Removing/Replacing (Sanding base plate)
> The sanding base plate can be removed following the reverse actions as
instructed for “attaching”.
> Check for damage and wear, clean the tool holder from dust and attach a new
one if necessary.
Plunge/segment saw blade, Scraper
Attaching
> Open the SDS tool holder (6) by opening the SDS clamping lever (1) fully (
Fig. 1
，
step 1).
> Slide desired tool attachment (8, 9, 10 or 12) onto the SDS tool holder (6) and
> Fix the tool attachment (8, 9, 10 or 12) by closing the SDS clamping lever (1)
fully (Fig. 1, step 3).
> Check if the tool attachment (8, 9, 10 or 12) is reliably clamped and make
adjustment if necessary.
Adjusting
WARNING!
Only adjust the scraper (12) and plunge saw blade (8 or
10) at the angle within range of -90° - +90°. Never adjust the scraper
and plunge saw blade pointing backward (Fig. 7, 8).
Never adjust the segment saw blade (9) at any angles other than 0°
(Fig. 9).
8
9
7/10
Fig. 4
Fig. 5
Fig. 6
