Intended use
Cutting plate adjustment
Forward/reverse operation
Forward/reverse operation
This shredder TTB683SHR is designated with a rated power input of 2500 Watts
(S6:40%)
This product is designed for cutting of fibrous and woody garden waste for
composting.
This product is not intended for shredding pieces of metal, rocks, bottles, cans,
etc. or soft waste such as kitchen rubbish.
For safety reasons it is essential to read the entire instruction manual before first
operation and to observe all the instructions therein.
This product is intended for private domestic use only, not for any commercial
trade use. It must not be used for any purposes other than those described.
WARNING!
Always switch the forward/reverse switch to standby
mode for 2 seconds before changing the forward/reverse mode!
Wait until the blades completely stop;
Wait at least one minute and then press the reset button (16);
Set the forward/reverse switch (13) to reverse mode “ ”;
Press the ON switch “I” (15) to switch the product on. Carefully pull out
the jammed material from the feeding funnel;
After the product runs for a few seconds, press the OFF switch “O” (14)
to switch the product off;
Set the forward/reverse switch (13) to forward mode “ ”;
Always adjust the clearance between the cutting plate(4c) and
cutting blades (4b) before using the product!
For an effective operation, adjust the blade clearance regularly.
NOTE:
Repetitions of forward and reverse operations may be
required to shred a large object.
The cutting plate(4c) is set from 0 to 0.5 mm closed to the cutting blades(4b); this
distance should be kept to achieve effective operation.
Switch the product on.
Turn the cutting plate adjustment knob (5) slowly in a clockwise direction until
a scraping noise is heard (metal plate making contact with the cutter head).
Fine aluminium shavings will fall from the discharge chute (Figs. 7, 8).
As soon as the scraping noise is heard, rotate the adjustment knob
anti-clockwise 1/4 of a turn. Ensure that the metal plate is not making contact
with the cutter head.
Avoid unnecessary wear on the cutting plate by not over-adjusting.
After adjusting, make shredding tests to check if the best effect is achieved.
Readjust if necessary.
>
>
>
>
>
5
+
-
Fig. 7
4b
4c
Fig. 8
Position
Operation mode
Application
Forward mode
Shredding
Standby mode
Switching between forward /
reverse mode during operation
(time interval: min. 2 seconds)
Reverse mode
Releasing jammed material
The motor of this product is equipped with an overload protection. When
overloaded, the product acts as following:
The overload protection unit will automatically activate within 4 – 10 seconds
and shut off the power supply.
When it happens, perform the following steps:
>
>
>
>
>
>
>
>
TTB683SHR
by TITAN
TTB683SHR
by TITAN
Products functions
Products functions
22
23
