Basic Installation-
Connect All Of the Following Wires
Main Connector (6pin)
PURPLE
Starter Output
- 12volts during start position only.
ORANGE
Heater/Acc Output
- 12volts in the accessory position off during
start and 14volts during run.
RED
12volt 30amp Input
- 12volts from ignition harness or battery.
RED
12volt 30amp Input
- 12volts from ignition harness or battery.
PINK
Ignition Output
- 12volts in the ignition, start and run positions.
PINK/
Selectable Output
- Selectable Output for vehicles that may
WHITE*
require a 2nd Ignition, Accessory or Start.
Auxiliary Connector (14pin)
BLACK
System Ground Input
- Connect to Chassis Ground.
WHITE
Park Light Output
- Connect to Park Light system.
GRAY
Hood Pin Input
- Connect to the Hood Pin Safety Switch.
VIOLET/WHT*
Tach Input
- Connect to A/C Tach source. (Above 2 volts AC)
PINK
Brake Switch Input
- Connect to (+) when the brake pedal
is applied.
System Reset
The system reset will clear any changes made to the Program Menu’s as well
as the Tach setting. When the system reset is complete the system must be
Tach learned before the remote starter will operate.
1)
Turn the ignition key from “Off” to “On” 3 times,
ON-OFF-ON-OFF-ON
within
three seconds
.
(Leave the key in the
ON
position)
2)
Press and release the
Program Button
located on the antenna. The park
lights will turn on and the horn (optional) will honk one time.
3)
Then press and hold the
Program Button
until the park lights flash and the
horn (optional) will honk 3 times slowly to confirm system reset.
System is now reset to factory defaults
.
NOTE:
System Reset
does not
delete the transmitter codes from memory.
* See the following pages for more detailed programming instructions.
INSTALLATION MANUAL
TS141A REMOTE STARTER
