Tippmann FT-12, Руководство пользователя

Страница: 4 / 70

4
E
N
G
L
I
S
H
WARNING
Always keep the barrel blocking device installed except
when your marker is in use. Always make sure that
the trigger safety is in the Safe mode (see instructions
on page 6) and the barrel blocking device is properly
installed on your marker according to the instructions to
prevent damage to property, serious injury, or death.
Barrel Blocking Device Installation Instructions
1. Place the barrel blocking device onto the barrel
muzzle and loop the cord over the top of the
receiver and position at the back of the hinge
as shown.
2. Adjust the cord length retainer up to the back
of the marker by pulling the cord through it until
the retainer is snug against the back of the
marker. Keeping the cord as tight as possible, leave
just enough cord elasticity to pull the cord/retainer
up over the top of the marker to remove the barrel
blocking device for firing.
3. After the cord length is properly adjusted, lock the
cord length by tying a knot in the cord against the
back of the cord retainer as shown.
4. Before and after playing, inspect the barrel blocking
device. Replace the barrel blocking device if the
sleeve or cord is damaged, or there is a loss of
cord elasticity.
5. Clean the barrel blocking device with plain, warm water
and store out of direct sunlight in a dry area when not
in use.
Cord
Length
Retainer
WARNING
This is not a toy. Misuse may cause serious injury or
death. Eye, face, and ear protection designed for paintball
must be worn by the user and any person within range.
We recommend you be at least 18 years old to purchase.
Persons under 18 must have adult supervision when
using this product. Read the Owner’s Manual before
using this product.
Barrel Blocking Device
Place BBD cord
in this notch.