Tion O2 Lite, Руководство пользователя, Страница: 25 / 36

25
Depending on the factory sealing procedure, the device filters (base F7, HEPA E11
(Н11) and adsorption catalytic АK filter) may be supplied in protective plastic packag-
ing. Therefore, before first use, the filters must be unpacked (Fig. 18). Please do the
following:
1. Remove maintenance panel:
• push on the left and the right locks towards each other, releasing the panel
bottom corners;
• pull the panel, overcoming the force of the magnet lock, located at the bottom
of the maintenance panel.
2. Take out all filters for the given version from the packaging.
3. Unwrap each filter from the protective plastic film.
4. Install each filter into the device.
5. Reinstall the maintenance panel and make sure that both right and left latches
are clamped shut.
Figure 18. Filter preparation workflow
PLEASE NOTE!
• Avoid applying force to the latches during panel reinstallation, as this may
damage the device.
• The filters installed in the device may be wrapped in protective plastic
bags. Make sure to remove the protective film before starting operation. If
the device is turned on with filters still in plastic packaging, this may cause
damage and void the warranty obligations. The protective packaging does
not impact the quality of filters or their storage life inside the device.
• When new, the device may have the characteristic odor of plastic ware.
Such an odor most likely comes from the shipping package. Take out the
filters and turn on the device at the 3rd or 4th speed for several hours. If an
odor persists, please call the service center.