Tion O2 Lite, Руководство пользователя, Страница: 17 / 36

17
To select a system parameter to be changed, press the [SET] button. Switching
between the parameters is also achieved by sequential pressing of the [SET] button.
When selecting a parameter, its icon on the LCD display will start blinking.
If the parameter value can be set, then one pressing of the [-] or [+] button changes
the value by one unit of measurement. To change the parameter value by several units,
press and hold the [-] or [+] button for more than 1 s until you reach the desired value.
No. Adjusted parameter Button functions
1 Target air temperature* [-]: -1°С, [+]: +1°С
Heater* [-] and [+] for 2 s: on/off
2 Current time** [-]: +1 hr, [+]: +1 min
3 Timer on/off*** [+] or [-]: on/off
4 Timer value for device launch*** [-]: +1 hr, [+]: +5 min
5 Timer value for device stop*** [-]: +1 hr, [+]: +5 min
6
Minimal admissible inlet air
temperature****
[+]: next value, [-]: previous value
7 Filter Service Interval
[+]: +30 days, [-]: -30 days; [-] and [+] for 2
s: 360 days
* A heater is not installed in Tion О2 Lite Lite configuration.
** If MagicAir is connected, the parameter cannot be adjusted.
*** If the device is under control of MagicAir, the parameter cannot be adjusted.
**** Available values of the parameter: -25°С, -30°С, -35°С, -40°С.
The target temperature and fan speed have limiting values, which cannot be
looped: after the maximal value is reached, further pressing of the [+] button will not
cyclically bring the parameter back to its minimal value; instead the maximal value
will be kept. All other parameters are looped, which means that after their maximal
values are reached further pressing of the [+] button will cycle the parameter back to
its minimum.
To accept and save the settings and move to another parameter, do one of the
following:
• press and hold for 2 s the [SET] button (this action is not available from the RC),
• do not press any other buttons for 10 s.
A single beep will sound, confirming the changes have been saved and updated.
Simultaneously pressing 4 buttons: [SET], [-], [+] and (not available from the
RC) will reset all user settings to factory defaults. This function is not active when a
parameter is being set.