Hi-Performance Wash Systems Car Wash Equipment and Parts Supplier to the Rocky Mountain Region
possibility of damage. When properly installed, the TIMEMASTER will (in most cases) simply slide backwards off the shelf if the customer strikes the coin box. A mounting
bracket for the timer can be manufactured from metal and welded or bolted to the inside of the coin box faceplate. (Hi-Performance Wash Systems has several designs of
TIMEMASTER mounting shelves available for purchase.)
Once the mounting bracket has been installed on the coin box faceplate, secure the timer using the supplied wing nut as shown in figure 1. Only slightly tighten the wing
nut, as this will allow the timer to recoil to the real if the coin box is struck.
ELECTRICAL INSTALLATION
Provided with the TIMEMASTER are two (2) pre-wired connectors. These wires are to be connected to the site wiring as instructed on the following page. Improper
connections could damage the timer or prevent function from operating correctly. Please read and understand all connection requirements before proceeding with the
installation. TIMERS DAMAGED BY INCORRECT CONNECTION ARE NOT COVERED BY THE TIME MASTER WARRANTY.
Determine the proper polarity of the connectors before connecting the attached wiring. While it is difficult to connect the plugs upside-down, the will fit! Refer to Figure 2
for pin numbering and polarity. The pin numbers are also indicated on the timer's rear label.
http://www.hpws.com/tech/tmman.htm (3 of 15)3/29/2007 12:19:49 PM