Hi-Performance Wash Systems Car Wash Equipment and Parts Supplier to the Rocky Mountain Region
INITIAL SETUP
These instructions are for programming the TIMEMASTER when it is first installed. You may reprogram the timer using these same steps however, the display number will
reflect the current program instead of what is indicated by the chart. You may also reprogram the TIMEMASTER with the optional infrared remote control. See REMOTE
CONTROL PROGRAMMING for details.
The MODE switch cycles the timer through its 12 steps of programmable steps. These steps are shown in the following flow chart (figure 7)
After the MODE switch moves to the option step, the SET switch causes the number displayed to increase by one unit value. Holding the switch depressed for more that 2
seconds will increase the count rapidly. If you pass the desired number, continue to depress the SET switch until the display counts to its maximum value and starts over.
Once the timer has been programmed, the built-in memory will maintain the program even if the timer is unplugged.
WARNING! The timer's memory includes its timed output. If power is removed from the timer during a timing operation, the unit will activate its controlled device when the
power is restored.
http://www.hpws.com/tech/tmman.htm (9 of 15)3/29/2007 12:19:49 PM
