Hi-Performance Wash Systems Car Wash Equipment and Parts Supplier to the Rocky Mountain Region
INITIAL SETUP - PROGRAMMING
When the wiring has been properly connected, and the plug has been installed into the timer, turn on the power to the device. The timer's display will flash:
"$.50...TO...WASH".
The timer's default programming is set to $.50 for 1 minute. To change the program, depress and hold the MODE button until the display reads "MENU". Press and
release the MODE button again and the display will read:
A:02
MENU A (Price to start)
This menu sets the number of coins required to start the equipment. If you wish to set the timer to start on $1.00, this number will be set to 4, (4 quarters = $1.00). A $2.00
starting price is therefore 8, (8 quarters = $2.00). To change the PRICE TO START, depress and release the SET button once for each number increase you desire. Once
the correct number is displayed, depress and release the MODE button. This display will now read:
b:00
MENU B (Seconds)
This menu sets the seconds your equipment will operate once the minimum amount to start has been deposited. Most car wash equipment operates on a 4-minute cycle.
However, some facilities are set to run at 3:30 per cycle. To set an even minute cycle leave this number at :00.
To change this number, depress and release the SET button until the desired number of seconds is displayed.
Once the correct number is displayed, depress and release the MODE button. The display will now read:
C 1:00
MENU C (Minutes)
This menu sets the minutes your equipment will operate once the minimum amount to start has been deposited. Most car wash equipment operates on a 4-minute cycle.
However, some facilities are set to run at 3:30 per cycle.
To set the minute cycle, depress and release the SET button until the desired number of minutes is displayed.
Once the correct number is displayed, depress and release the MODE button. The display will now read:
http://www.hpws.com/tech/tmman.htm (10 of 15)3/29/2007 12:19:49 PM