Timberwolf TW 280FTR (Petrol), Инструкция по эксплуатации

Страница: 52 / 68

5.19 Track Base Maintenance
WARNING
ALWAYS ENSURE THAT THE CHIPPER IS CORRECTLY AND
SAFELY SUPPORTED FOR ANY OPERATIONS THAT REQUIRE IT
TO BE RAISED FROM THE GROUND.
1. Ensure the chipper is correctly supported (Refer to Section 5.18 " Jacking the Chipper"
on page 49.
2. Hydraulic systems may get very hot after working.
3. Keep all components in good condition as they are exposed to high pressures.
4. Immediately repair damage and replace worn or broken items.
5. Keep the tracks clean, removing excess oil, grease and dirt.
6. Check for oil leaks and damaged hoses.
7. Only use recommended lubricants. Do not mix different brands.
8. Keep the track adjuster unit grease nipples clean.
5.19.1 Checking Track Tension
To prevent damage to the rubber tracks they should be checked every day to ensure they
are at the correct tension.
1. Stop the machine on a flat and solid surface
and turn the engine off.
2. Measure from the ground to the inside edge
of the track at the top central location (Figure
36, Item 1).
3. Pull the top centre of the track firmly
upwards and measure the deflection from
the initial measurement (Figure 36, Item 2).
4. The track tension is correct if the deflection
is between 30 mm and 40 mm.
5. If the deflection is outside the recommended
limits, the track tension should be adjusted.
(Refer to Section 5.19.3 "
Adjusting Track
Tension" on page 52.)
Figure 36 - Checking Track Tension
50/66 C190-0308 - Rev 1.0 EN
TW 280FTR (Petrol) 5 Maintenance Instructions