Timberwolf TW 280FTR (Petrol), Инструкция по эксплуатации

Страница: 42 / 68

5.7 Check and Replace Fasteners
Timberwolf recommend that any nuts or bolts which are disturbed during the course of
operation or maintenance should be inspected by the operator for signs of wear or stress. If
any doubt exists over the serviceability of the fasteners then they should be replaced with
new items to the same specification. Use only Timberwolf fasteners, as they are of a higher
grade. Failure to use the appropriate grade may result in damage, injury or death.
The Timberwolf TW 280FTR is subject to large vibrations during the normal course of
operation.
All fasteners must be periodically checked to ensure they have not worked loose. They
should be tightened to the correct torque, using a calibrated torque wrench. (Refer to Table
5.)
An uncalibrated torque wrench may be inaccurate by as much as 25% and result in
fasteners being either too loose, or overtightened.
Size Pitch Head Torque
Nm ft-lb
Blade Nuts M16 Standard 24 mm Hex 170 125
Anvil Bolts M12 Standard M12 Cap 88 65
General M8 Standard 13 mm Hex 27 20
General M10 Standard 17 mm Hex 61 45
General M12 Standard 19 mm Hex 88 65
Track Frame Bolts M16 Standard 24 mm Hex 108 80
Fuel Tank Feed Line 1/4" BSP - 19 mm Hex 20 15
Fuel Tank Drain Plug 3/8" BSP - 22 mm Hex 20 15
Hydraulic Tank Feed Line 1/4" BSP - 19 mm Hex 20 15
Hydraulic Tank Drain Plug 3/8" BSP - 22 mm Hex 20 15
Table 5 - Torque Wrench Settings
40/66 C190-0308 - Rev 1.0 EN
TW 280FTR (Petrol) 5 Maintenance Instructions