Timberwolf TW 280FTR (Petrol), Инструкция по эксплуатации

Страница: 15 / 68

C190-0308 - Rev 1.0 EN 13/66
2.5 Instruction Decals
Pt No Description
670
Personal Protective Equipment required. (Section 3.2 " Operator's Personal Protective
Equipment (PPE)" on page 17.)
1399
Push safety bar to stop.
1661
Refer to the instruction manual for greasing and maintenance information.
1662
The instruction manual with this machine contains important operating, maintenance and
health and safety information. Failure to follow the information in this instruction manual
may lead to death or serious injury.
2800 Reverse feed.
2801 Forward feed.
2949
Lifting eye is designed to lift the machine's weight only. Do not use hoist on lifting eye. Use
correctly rated safety shackle only through lifting eye. Lifting eye to be inspected every 6
months and prior to each use. Do not use lifting eye if damaged.
3022
Clean under blades before refitting or turning. Failure to do so may result in blades coming
loose and damage being caused to the rotor housing.
3059
Jacking point.
Refer to Section 5.18 " Jacking the Chipper" on page 49.
18393
New drive belts need re-tensioning. When new belts are fitted check tension every 2-3
hours and adjust until tension remains constant.
18653
Close bucket and point discharge away from driving position. Protective equipment must
be worn when driving machine.
19517
WARNING - Do not engage starter motor for more than 20 seconds. Allow one minute
before attempting to start. Investigate reasons for failure to start. Excessive cranking will
result in starter motor failure. This will not be covered under warranty.
Table 3 - Instruction Decal Descriptions
2 Product Details TW 280FTR (Petrol)