Timberwolf TW 280FTR (Petrol), Инструкция по эксплуатации

Страница: 27 / 68

C190-0308 - Rev 1.0 EN 25/66
Engine Stop Switch
Pushing the Engine Stop Switch on top of the engine bay will cause the engine to run
down and stop in the shortest possible time from its current operating status.
The engine cannot be restarted until the Engine Stop Switch is reset and the main
ignition switch is turned off to reset the machine.
N.B. The feed rollers will NOT stop immediately, but will stop as the engine falls below
the pre-set ‘No Stress’ speed (See Section 4.2 "
No Stress Control" on page 24).
Emergency Stop Button (Timberwolf Safety Plus Kit Only)
Pushing any one of the Emergency Stop Buttons on the top of the funnel, or either side
of the feed tray, will remove all power to the engine AND the feed rollers, bringing the
whole machine to a complete stop.
The engine cannot be restarted until the operated Emergency Stop Button is reset and
the main ignition switch is turned off to reset the machine.
4.4 Discharge Controls
Controlling the direction and angle of the discharge is an essential part of operating the
chipper in a safe manner.
Discharge Direction
1. Slacken the locking nut using the integral handle (Figure 5).
2. Rotate the discharge tube to face in a safe direction.
3. Re-tighten the locking nut.
Discharge Angle
Use the handle to adjust the bucket to achieve a safe discharge angle (Figure 6).
Figure 5 - Discharge Tube Locking Nut Figure 6 - Discharge Bucket
4 Operating Instructions TW 280FTR (Petrol)