Timberwolf TW 280FTR (Petrol), Инструкция по эксплуатации

Страница: 51 / 68

C190-0308 - Rev 1.0 EN 49/66
5.17 Securing the Chipper for Transport
Securing the TW 280FTR ready for transport must be carried out by a competent
person, to the satisfaction of the driver to ensure compliance with all local legislation.
Securely stow the feed funnel and operator step
and tighten the discharge tube, facing forwards.
The method of securing the TW 280FTR may
vary depending on the type of carrier and the
position of the tie down points available on it.
The carrier must be of suitable design and
capable of safely and legally transporting the TW
280FTR.
Wherever possible, the approved tie down points
on the outer sides of the chassis beams should be
used (Figure 34).
The use of any other unapproved points may
result in damage to the machine.
Figure 34 - Tie down points
5.18 Jacking the Chipper
The TW 280FTR is fitted with a jacking beam, which can be extended from either side of
the machine to enable it to be safely raised for maintenance. A correctly rated jack is
supplied with the chipper, stowed on the chassis beam beneath the funnel.
The chipper must be on firm level ground. Use the supplied jack to lift the chipper via
the jacking beam. Do not go under the chipper while it is supported on the jack.
1. Remove the cover plate lower securing
bolt and loosen the upper securing bolt.
2. Rotate the cover plate to expose the end
of the jacking beam.
3. Pull the jacking beam out to its fullest
extent (approximately 300 mm).
4. Remove the pin securing the jack to the
machine chassis.
5. Attach the jack to the jacking beam using
the same pin that held it on the chassis.
6. Use the jack to raise the machine
sufficiently for the required task.
Figure 35 - Extending Jacking Beam
7. After use, lower the machine safely to the ground, remove and stow the jack, push
the jacking beam back into place and secure the cover plate.
5 Maintenance Instructions TW 280FTR (Petrol)