Timberwolf TW 280FTR (Petrol), Инструкция по эксплуатации

Страница: 44 / 68

between the blade and rotor will cause the blade to become loose very quickly.
12. Ensure that the mounting bolts and nuts are suitable for re-use. (Refer to Section 5.7
" Check and Replace Fasteners" on page 40.) If any doubt exists, use new items.
13. Apply a smear of anti-seize compound (copper ease) to the bolt threads and back face
of the nuts. DO NOT apply copper ease to the counter-bore faces of the blades or
bolts.
14. Fit the blade to the rotor using the retaining bolts, washers and Nyloc nuts. The use of
genuine Timberwolf blades and bolts is recommended (Figure 24).
15. Tighten the blade bolts to the correct torque
setting. (Refer to Section 5.7 " Check and
Replace Fasteners" on page 40.)
Figure 24 - Blade Mounting
16. Remove the locking bar from the rotor housing
and the rotor. Rotate the rotor until the next
blade is visible through the access hatch and
repeat from step 5 onwards.
17. Refit the rotor housing blade access hatch and
the retaining nuts and washers.
18. Tighten the hatch retaining nuts to the correct
torque setting. (Refer to Section 5.7 " Check
and Replace Fasteners" on page 40
19. Refit the drive belts and correctly adjust their tension. (Refer to Section 5.9 " Adjust
Rotor Drive Belt Tension" on page 43.)
42/66 C190-0308 - Rev 1.0 EN
TW 280FTR (Petrol) 5 Maintenance Instructions