TIL TST-4100 92-SC, Инструкция по установке и эксплуатации

Страница: 15 / 48

TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TST-4x00 92-SC Installation & Operating Instructions TiL 93RE126 Rev F
2-1
SECTION 2 – PREPARATION FOR USE AND STORAGE
2.1 INTRODUCTION
This section provides the information required for custom configuration and storage of the Single
Channel Transmitter. Custom system configuration includes customizing the remote control board
functions and the transmit frequency selection.
2.2 DISASSEMBLY/ASSEMBLY
(Refer to Figure 2.1)
2.2.1 Remove/Replace Top Dust Cover Assembly
REMOVAL
(1)
Remove and retain twelve screws securing top dust cover to the 19" rack chassis.
(2) Please note the location of the three longer screws which travel through the heatsink
shims riveted to the inside of the top cover.
(3) Lift cover clear of chassis to expose internal view of transmitter as shown in Figure 2.1.
REPLACEMENT
(1)
Position top cover on chassis.
(2) Position one screw in each corner of the top-cover mounting holes. Place the three
longer screws into their correct holes located over the internal transmitter module.
(3) Secure cover to chassis with remaining screws.
2.2.2 Remove/Replace Transmitter Module
REMOVAL
(1)
Remove dust cover as described in paragraph 2.2.1.
(2) Disconnect RF and DC connectors from rear of transmitter module.
(3) Remove and retain the screws securing the top cover of the internal transmitter module.
(4) Remove and retain two screws and two washers securing flat cable to the side of the
transmitter module and disconnect the flat cable. Disconnect the flat cable running out of
the transmitter module at the connector on the external memory set board.
(5) Remove and Retain four countersunk screws securing transmitter module to front panel.
(6) Move the transmitter module slightly back from the front panel and disconnect the flat
cable connecting the front panel assembly to the transmitter module, audio interface
board A3. The connector is located on the A3 board.
(7) Lift transmitter module clear of chassis.