TIL TST-4100 92-SC, Инструкция по установке и эксплуатации

Страница: 31 / 48

TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TST-4x00 92-SC Installation & Operating Instructions TiL 93RE126 Rev F
3-1
SECTION 3 – OPERATING INSTRUCTIONS
3.1 INTRODUCTION
This section includes a functional description of each switch, control, indicator and connector
located on the front and rear panels of the Single Channel Transmitter, including the PRESS-TO-
TALK switch located on the microphone. Operating instructions for transmit in the local or remote
mode are also included.
3.2 INSTALLATION
The Single Channel Transmitters are designed for mounting in a 19 inch rack. An AC Line cord
P/N 927002-1 is supplied for connection to AC Power. A 9 Pin connector (mates with Positronic
GM9MSCG000VL or equivalent) and a 25 Pin Connector (mates with Amphenol 17D-B-25S or
equivalent) are provided for connection with external DC and 2 Wire 600 ohm lines. A 50 ohm "N"
Type connector is provided for connection to an external antenna. Refer to Section 2, for
frequency selection and remote control setup details.
(1)
Mount Transmitter in 19 inch rack with 4 screws.
(2) Install Microphone in Microphone (PTT) connector if required.
(3) Ensure that Transmitter POWER ON/OFF switch is set to OFF.
(4) Install AC line cord in AC chassis connector on rear panel.
(5) Install Remote Control connector to 9 Pin or 25 Pin connector as required. (Refer to
Figure 3.1 for connector pinouts.)
(6) Connect antenna connector to rear panel chassis N Type connector.
3.3 OPERATOR'S SWITCHES, CONTROLS AND INDICATORS
A view of the front and rear panel is given in Figure 3.1. A functional description of each of the
operator's switches, controls and indicators, and the microphone PRESS-TO-TALK switch, is
given in Table 3.1, Operator's Switches, Controls and Indicators.