TIGIEFFE AIRO R Series, Руководство по эксплуатации и обслуживанию

Страница: 74 / 114

Use and Maintenance Manual - R13 R17 Series Page 74
When no pads are resting on the ground:
 all the outriggers position green warning lights are off;

the controls of “Platform movement” mode (lifting/lowering/rotation) are inhibited;

the controls of wire control mode are available.
With one or more pads not resting on the ground:

the outriggers position green warning lights relevant to lifted pads are off;

“wire control” mode controls (translation and stabilization) are inhibited;

if the boom is lifted, lifting and telescopic boom extension are inhibited; lowering and turret rotation at an automatically reduced
speed are available.
7.2.14. “Dead-man” safety system operation check
The dead-man pedal and button at platform are for enabling the operation controls of the machine from the platform control panel.
The operator can choose to use the most convenient enable device depending on the real position of the platform control panel.
Check operation at least once a year.
WARNING!
IN CASE OF NO OPERATION, CONTACT THE AFTER-SALES SERVICE
7.2.14.1. "Dead-man" pedal”
To check the dead-man PEDAL:
 Move the drive joystick forward and backward in sequence, WITHOUT PRESSING THE dead-man PEDAL.
 Check that the machine does not perform any movement.
 Hold down the dead-man pedal for more than 10 seconds.
 With the pedal pressed, move the joystick forward and backward in sequence.

Check that the machine does not perform any movement
If the device works properly, no machine movement is possible on the platform control panel unless you press the dead-man pedal
beforehand. If this is pressed for more than 10 seconds and no operation is performed, all movements are disabled; to operate the
machine again, release the dead-man pedal and press it again.
The condition of the switch is indicated by the green led in the platform:

green led lit up steady control panel enabled

green led lit up flashing control panel disabled
7.2.14.2. "Dead-man" button
To check the dead-man BUTTON:

move the drive joystick forward and backward in sequence, WITHOUT PRESSING THE DEAD-MAN BUTTON

check that the machine does not perform any movement

press “dead-man” button, release it and wait more than 3 seconds

move the joystick forward and backward in sequence

Check that the machine does not perform any movement.