TIGIEFFE AIRO R Series, Руководство по эксплуатации и обслуживанию

Страница: 38 / 114

Use and Maintenance Manual - R13 R17 Series Page 38
5.1.2. Mode “Platform movement”: Lifting/Lowering/Rotations
To use the controls of the operating mode “Platform movement”
(Lifting/Lowering/Rotations) carry out the following preliminary
operations in the sequence below:
1. Once the machine has been correctly positioned
according to the previous paragraphs, reposition the
control panel on the magnetic support on the platform
and lock the cable on the supports.
2. Get on the platform;
3. Select the operating mode “ Platform Movement ” by
setting selector R to position 2 ; Control the desired
movement following the instructions in the next
paragraphs.
In “Platform movement” mode, the proportional control levers
have the following functions:
H) Platform Rotation proportional control lever (Optional)
I) Turret Rotation proportional control lever
L) Jib up/down proportional control lever
M) Telescopic extension/retraction proportional control lever
N) Second boom lifting/lowering proportional control lever
O) First boom lifting/lowering proportional control lever.
When the booms are resting on the turret (low platform),
platform level compensation control
C is active.
Fig.13
WARNING!!
If the audible alarm and red warning light ZE on the control panel turn on, the machine is not correctly
positioned; stabilization is necessary to operate the machine again.
When the platform is lifted if one of the feet looses contact with the ground, the corresponding warning light
ZA turns off, danger red light ZE turns on and all lifting movements are inhibited. Cage lowering on the ground
is still possible (lowering and turret rotation in both directions) at automatically reduced speed.
To avoid improper use, a special microswitch checks the position of the lifting boom. When the second boom