TIGIEFFE AIRO R Series, Руководство по эксплуатации и обслуживанию

Страница: 31 / 114

Use and Maintenance Manual - R13 R17 Series Page 31
A) Dead-man button
B) Horn button
C) Platform level compensation switch
D) Automatic stabilization control switch (optional)
E) Electric motor start / stop button (optional)
F) Electric / thermic power selector (petrol motor)
G) Heat motor starting switch
H) Platform rotation control proportional lever (optional) / RIGHT track drive
I) Turret rotation control proportional lever / front RIGHT outrigger (B)
L) JIB up-down control proportional lever / back RIGHT outrigger (D)
M Telescopic boom in-out control proportional lever / back LEFT outrigger (C)
N) Boom up-down control proportional lever / front LEFT outrigger (A)
O) Scissors up/down control proportional lever / LEFT track drive
P) Emergency STOP button
Q) No function
R) Controls mode selector: platform movement / wire control (translation and stabilization)
S) Dead-man pedal
T) Enabled electric pump warning light (optional)
U) Tracks widening control switch (optional)
ZA) Outriggers position warning lights
ZB) Enabled control panel warning light
ZC) In-centre turret warning light
ZD) Low fuel / Diesel motor anomaly warning light – Not active for machines with petrol motor
ZE) Danger warning light (unsteady position and faults indicator)
ZF) No function , the machine is not equipped with a platform load control system as in the design phase we considered
stability and overload criteria increased as reported by the EN280 in paragraphs 5.4.1.5 and 5.4.1.6.
All movements (except for platform rotation and platform level compensation) are controlled by proportional joystick /levers; it is
therefore possible to adjust movement speed by means of the relative controls. To avoid sudden shakes during movements, it is
advisable to operate the proportional joystick controls gradually.
For safety reasons, to operate the machine, it is necessary to press “dead-man” pedal S or “dead-man” button A at platform before
operating the controls. If the dead-man pedal is accidentally released while the machine is operating, the movement is immediately
stopped.
During platform positioning with operator on board, the controls can be enabled using the “dead-man” pedal; during translation and
stabilization movements with operator on the ground, controls must be enabled using the “dead-man” button.
WARNING!
Holding down the dead-man pedal for over 10 seconds without carrying out any operation will disable the
control panel. Once the dead-man button is pressed, you have 2 seconds to activate the controls. If no
operation is performed after 2 seconds, the control panel is disabled.
The disabled control panel condition is indicated by the flashing green led (ZB). To operate the machine
again it is necessary to release the "dead man" pedal and press it again; the green led (ZB) will light up
steady and for the next 10 seconds all controls will be enabled.