Thunder 75P-T6-Multi-Charger, Руководство пользователя

Страница: 7 / 37

and series circuits mixed. You have to check the
composition of the battery pack carefully before charging.
4)Be sure all the connections firm and safe, on
intermittent contact at any point in the circuit.
General notes on operating it .
Charging
A specific quantity of electrical energy is fed into the
battery during charge process. The charge quantity
is calculated by multiplying charge current by charge
time. The maximum permissible charge current varies
according to the battery type or its performance, and
can be found in the information provided by the battery
manufacturer. It is only allowed to charge batteries at
rates higher than the standard charge current if they are
expressly stated to be capable of quick-charge.
Connect the battery to charge to output terminal of
the charger using suitable charge lead. They are red,
positive (+) and black, negative (-). Since the charger
cannot detect the difference between the internal
resistance of the battery pack, cable resistance and
connector transfer resistance, the first requirement if the
charger to work properly is that the charge lead should
be of adequate conductor cross-section. And also high-
quality connectors (normally gold-contact type) must be
fitted to both ends.
Refer to the information provided by the battery
manufacturer regarding charging methods, and verify
the recommended charge current and charge time.
Especially for Lithium batteries, you have to follow the
charge instruction provided by the manufacturer strictly.
Do not attempt to disassemble the battery pack