Thrane&Thrane EXPLORER 122, Руководство пользователя

Страница: 33 / 50

EXPLORER 122
User Manual
98-150578-A 3-12
To configure the access point settings set the following:
1.
SSID – This is also known as your network name. Provide a unique SSID for the network.
The name must not exceed 32 characters.
2. Network Password – The terminal uses WPA2 encryption and requires a password. Use
this field to set the network password for the WLAN. The network password must be at
least 8 characters long but cannot be more than 63 characters.
3. Channel – Choose a transmit channel for your WLAN. Channels 1,6, and 11 are the
primary transmission channels used. If interference is experienced on those channels
then use one of the other channels.
4. Click Save.
Figure 3-12. WiFi Interface Pane
3.4.5 Satellite Interface
Configure the satellite interface transmit settings. These settings can be used to inhibit
terminal transmissions, both in real-time and at boot up (Figure 3-13).
NOTE : If terminal transmit is inhibited at boot up it will not be able to
communicate on the VMS network until transmit is enabled.
Figure 3-13. Satellite Interface Pane
The IP Address and Subnet Mask fields contain the external (Satellite Interface) address
configuration assigned to your terminal. These fields are assigned by your service provider.
Current Transmit State – Allows you to disable your terminal’s ability to transmit. For
normal operation, this should be set to Enabled. If disabled, your terminal will not be able to
send data over the satellite interface.
Transmit State at Power Up – Allows you to alter the power-up behavior so that the
terminal will not transmit when powered up. For normal operation, this should be set to
Enabled. If disabled, your terminal will not be able to send data over the satellite interface
upon power-up.