Please note, some software programs will not function with a TT-USB, but require use of a PRO-SB in
its place.
Connecting the Encoder,
TT-USB and Sensors
SETTING UP THE ENCODER UNIT
Cut a convenient length of fiber optic cable cleanly and evenly using a sharp blade, or use the
whole length rolled up out of the way.
IMPORTANT: Winding the fiber optic cable in a loop smaller than 4 inches (10 cm) or bending it sharply
will damage the cable!
1.
Plug the USB cable connected to the TT-USB interface unit supplied with the USB
connector on the computer being used. (If using the BioGraph
®
2.1 software please use
the Pro-SB in place of the TT-USB as described in the BioGraph
®
2.1 software manual.)
2.
Insert one end of the fiber optic cable into the optical receiver jack on the rear face of
the TT-USB Interface unit and the other into the optical transmitter jack on the front of
the ProComp Infiniti encoder. Before inserting the cable, it may be necessary to loosen
the jack heads by turning them counter-clockwise.
3.
Ensure that both ends of the optical cable are inserted all the way (about ¾ of an inch,
1.9 cm) into the jacks and that the heads are screwed down firmly.
4.
Wind excess fiber optic cable into a large loop (approx. 6 inches, 15 cm).
5.
Plug the sensors you wish to use into the input jacks on the front of the encoder unit.
6.
Load four 1.5 V Alkaline or rechargeable Nickel-Metal Hydride (NiMH) batteries into the
encoder unit’s battery pack; check battery orientation being sure to respect the polarities
indicated on the inside of the battery compartment.
7.
Push the encoder unit’s power button for 1 second.
8.
Check that the encoder’s blue ‘ON’ indicator directly above the ON button is lit; if it is
not, check the condition and orientation of your batteries.
9.
To switch the encoder ‘OFF’ push the power button for 1 second and ensure that the
blue indicator is no longer lit.
You may leave the encoder unit power ON if you intend to continue on to the following sections.
ProComp Infiniti Hardware Manual
9
Содержание Procomp Infiniti
Страница 2: ...ProComp Infiniti Hardware Manual 2...
