tightened firmly.
•
Make sure to remove electrodes from sensor snaps immediately after use.
•
Do not plug third party sensors directly into instrument inputs. Plug only Thought Technology
Active Sensor cable connectors into instrument inputs. All electrodes and third party sensors
must be connected to active sensors, either directly or through an adapter.
•
Remove batteries when the device is not being used for an extended period of time. Please
dispose of battery following local regulations.
CONTRAINDICATIONS
•
None
INTENDED PURPOSE
•
Biofeedback, Relaxation & Muscle Re-Education purposes.
NOTE
•
No preventative inspections required; maintenance must be performed by qualified personnel.
•
The supplier will make available, upon request, circuit diagrams, component parts lists and
description or other information required for the repair of product by qualified personnel.
•
If a fiber optic or patient cable is damaged or breaks please replace.
•
Due to the essential performance and intended use of the device, testing for immunity to
electromagnetic disturbances was not required and was not performed. The device may be
susceptible at levels below IEC60601-1-2 immunity test levels.
•
The operator must be familiar with typical characteristics of signals acquired by this equipment,
and be able to detect anomalies in the acquired signal that could interfere with treatment
effectiveness. Depending on the importance of signal integrity, it may be advisable to
continuously monitor the raw signals, in time and/or frequency domain, while the device is
being used for biofeedback or other purposes. If anomalies are observed on acquired signals,
and if you suspect a problem with electromagnetic interference, contact Thought Technology
for a technical note on identification and remediation.
MAINTENANCE AND CALIBRATION
•
Wipe encoder with a clean cloth
•
Factory testing and calibration ensure equipment accuracy and frequency response. The user
may invoke a self-calibration function that will recalibrate certain device parameters (see
section in manual). Contact Thought Technology for factory re-calibration if necessary.
STORAGE
•
Store in its original case at up to 90% humidity / 30C°
TRANSPORTATION
•
Transport in its original case
Guidance and manufacturer’s declaration – electromagnetic emissions
The Infiniti system is intended for use in the electromagnetic environment specified below. The
customer or the user of the Infiniti system should assure that it is used in such an environment.
Emissions test
Compliance
Electromagnetic environment –
guidance
RF emissions
CISPR 11
Group 1
The Infiniti system uses RF energy only for its
internal function. Therefore, its RF emissions
are very low and are not likely to cause any
interference in nearby electronic equipment.
RF emissions
CISPR 11
Class B
Harmonic emissions
IEC 61000-3-2
Not applicable
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Not applicable
The Infiniti system is suitable for use in all
establishments, including domestic
establishments and those directly connected
to the public low-voltage power supply
network that supplies buildings used for
domestic purposes.
Manual # SA7510 Rev. 6.0
ProComp Infiniti Hardware Manual
5
Содержание Procomp Infiniti
Страница 2: ...ProComp Infiniti Hardware Manual 2...
