Thought Technology Ltd. Procomp Infiniti, Руководство по оборудованию

Страница: 14 / 48

Battery Placement
Opening The Compartment
Looking at the underside of the ProComp Infiniti device, you will
see a long door in the plastic enclosure. Holding the encoder
with the connectors facing you and with the door up, push lightly
down and back with your thumbs on the door to slide it open.
Attention:
The internal workings of the ProComp Infiniti encoder is not intended
to be opened for repair except by qualified service personnel. The
tamper-evident seal under the batteries in the battery compartment
should not be removed or broken. Thought Technology may refuse to
honor the unit’s warranty if the seal is broken.
Polarity
When the compartment cover has been slid out, place four AA batteries in the slots, observing
the polarity as illustrated. Please note that a diagram of the correct battery polarity is embossed
on the inside surface of the compartment.
Closing The Compartment
Slide the door back into the ProComp Infiniti case, gently pushing it in until you feel the click of
the locking mechanism.
Keeping An Eye On The Battery Level
Since each sensor draws a small amount of power from the batteries when connected to the
ProComp Infiniti, it is better to connect only the sensors that are going to be used for a session
before you start recording; this will ensure maximal battery life. Most Thought Technology
software applications will display a battery power indicator; we recommend that you replace the
batteries as soon as this indicator falls below about 50% of the battery power.
COMPACT FLASH
The compact flash (CF) is used as an alternative storage medium for
data being recorded by the encoder. The CF card is a small square
approximately the size of a box of matches and is inserted into the
rear surface of the encoder with its label facing up. The encoder is
delivered with a protective insert in the compact flash slot. To
remove it, push the button next to the slot once to eject the button,
then push again to remove the card, pushing the button back in.
The CF card can then be inserted; you will notice that the CF card
can only be inserted one way into the encoder to protect from
incorrect insertion. When inserted properly it will be flush with the
encoder rear. Follow the procedure above to remove this card when
no longer required, and re-insert the protective insert. CF cards
require a CF card reader to transfer data to the PC. The CF cards
and reader can be purchased from most computer stores. Before its
ProComp Infiniti Hardware Manual 14