THORLABS BC207UV, Руководство по эксплуатации

Страница: 100 / 181

BC207 Series Chapter 6: Operation Instructions
Page 93
MTN026962-D02
Note
The first three entries ("AMD USB2.0 MTT Hub", "USB Test and Measurement Device (IVI)"
and the "APT USB Device") are hardware components of the M2MS extension.
7. Start the Beam Software. It should automatically connect to the Beam Profiler and to the
translation stage. This can be seen in the Beam Settings Panel:
8. Upon starting the Thorlabs Beam Software, the translation stage will be initialized and
homed automatically. This means that it is recognized in the tab Stage Selection and
moves to the 200 mm position in case it is not there yet. This can take a few seconds. The
initialization can be forced manually by clicking the "Refresh Stage List" button in the
Device
Selection window . After the stage is identified and its serial number is read from its
EEPROM, double click the DDS100(/M) button in the device selection window.
6.3.7 M² Measurement
Prior to starting the Beam Quality measurements with the M2MS and a BC207 Series Beam
Profiler, the beam of the laser under test needs to be aligned to the M2MS Measurement Sys-
tem. It is important that the beam center hits the center of the Beam Profiler's aperture at every
position of the translation stage. Please read the following section carefully and follow the in-
structions.
Please open the M2 measurement panel via the icon to arrive at the alignment and mea-
surement GUI.
To prepare for and perform a M2 measurement, please click the M
2
icon on the left side of the
window. The top panel shows the Alignment tab, the M
2
measurement tab, and the
Live Adjustment tab. Please start with the Alignment of your system.
14
94 93
93
93
122