THOMSON SpeedTouch, Руководство по настройке

Страница: 50 / 110

Chapter 5
Routed PPPoE
E-DOC-CTC-20051017-0167 v1.0
42
The PPP interface
Proceed as follows to create, configure and attach/connect the PPP interface:
1
Add a new PPP interface.
2
Create a route that will be injected to the routing table when the PPP link
comes up.
3
Configure the PPP interface.
4
Enable NAT before attaching the PPP interface.
5
Connect the PPP interface.
6
Execute
saveall
at the prompt to save this configuration.
=> ppp ifadd intf=RtPPPoE
=>
The SpeedTouch™ creates an IP interface with the name RtPPPoE and
will add the PPP tag behind the PPP interface. In this case it will save
the PPP interface as RtPPPoE_ppp. Look at the interface list for
verification.
=> ppp rtadd intf=RtPPPoE dst=0.0.0.0/0
=>
=> ppp ifconfig intf=RtPPPoE dest=RtPPPoE_eth user=johndoe@ISP
password=johndoe
=>
=> nat ifconfig intf=RtPPPoE translation=enabled
=>
=> ppp ifattach intf=RtPPPoE
=>
=> saveall
=>
For a complete description of all CLI commands, refer to the
SpeedTouch™ CLI Reference Guide.