THOMSON SpeedTouch, Руководство по настройке

Страница: 49 / 110

Chapter 5
Routed PPPoE
E-DOC-CTC-20051017-0167 v1.0
41
5.1.1 Routed PPPoE with NAPT
Configuration procedure
Proceed as follows to configure a Routed PPPoE entry:
1
Create, configure and attach/connect the ATM interface.
2
Create, configure and attach/connect the Ethernet interface.
3
Create, configure and attach/connect the PPP interface.
4
Check your configuration.
The ATM interface
Proceed as follows to create an ATM phonebook and the ATM interface.
1
Add a new ATM phonebook entry with the correct VPI/VCI values.
2
Add a new ATM interface with name RtPPPoE_atm.
3
Configure the new ATM interface with as destination the phonebook entry
created above. Define also the upper layer interface type.
By default, the encapsulation method will be LLC/SNAP.
4
Connect the ATM interface to the phonebook entry.
The Ethernet interface
Proceed as follows to create, configure and attach/connect the Ethernet interface:
1
Add a new Ethernet interface.
2
Configure the new Ethernet interface with as destination the ATM interface
created above.
3
Connect the ETH interface.
=> atm phonebook add name=RtPPPoE_ph addr=8.35
=>
If another phonebook entry with the same VPI/VCI already exists, you
will have to delete this entry first.
=> atm ifadd intf=RtPPPoE_atm
=>
=> atm ifconfig intf=RtPPPoE_atm dest=RtPPPoE_ph ulp=mac
=>
=> atm ifattach intf=RtPPPoE_atm
=>
=> eth ifadd intf=RtPPPoE_eth
=>
=> eth ifconfig intf=RtPPPoE_eth dest=RtPPPoE_atm
=>
=> eth ifattach intf=RtPPPoE_eth
=>