THOMSON SpeedTouch, Руководство по настройке

Страница: 28 / 110

Chapter 3
Routed Ethernet
E-DOC-CTC-20051017-0167 v1.0
20
Configuration procedure
In this procedure we will guide you via the CLI through the configuration process.
The configuration procedure consists of the following steps:
1
Create, configure and attach/connect the ATM interface.
2
Create, configure and attach/connect the ETH interface.
3 Create, configure and attach/connect the IP interface.
4
Assign an IP address to the IP interface.
5
Check your configuration.
The ATM interface
Proceed as follows to create an ATM phonebook and the ATM interface.
1
Add a new phonebook entry with name RtEthoa_ph, VPI/VCI =8.35.
2
Add a new ATM interface with name RtEthoa_atm.
3
Configure the new ATM interface with as destination the phonebook entry
created above.
By default, the encapsulation method will be LLC/SNAP.
4 Connect the ATM interface to the phonebook entry.
=> atm phonebook add name=RtEthoa_ph addr=8.35
=>
If another phonebook entry with the same VPI/VCI already exists, you
will have to delete this entry first.
=> atm ifadd intf=RtEthoa_atm
=>
=> atm ifconfig intf=RtEthoa_atm dest=RtEthoa_ph ulp=mac
=>
=> atm ifattach intf=RtEthoa_atm
=>