THOMSON Chipper Check II, Руководство пользователя

Страница: 22 / 38

22
Setup DTV306, DTV307 Chassis
Connecting the Chipper Check interface box to the chassis requires the following:
1. Interface Box
2. Parallel Printer Cable
3. Interface Cable 212118
4. TECI1 Adapter
Things to Consider
The DTV30x uses the TECI1 adapter. Make sure the switch is set to the position closest to
the white 3-pin convergence connector for chassis communication.
It is best to allow Chipper Check to be detected by the chassis and automatically enter the
Service Mode. This is accomplished by connecting the Chipper Check interface board to
the service connector on the I/O board. When the service mode is entered manually on the
DTV306 or DTV307, the DM module will not respond to FPA key presses or IR remote control
commands. When the service mode is entered automatically by connecting Chipper Check,
the DM module remains active.
Service Mode (Manually)
1. Press the TV·DIRECTV and Chan-DN buttons simultaneously and release them.
2. Select Service Mode to display the “P” and “V”.
3. When the ‘P’ & ‘V’ values appear at the bottom of the screen, press VOL-UP or VOL-
DN buttons on the FPA or a remote control to change the V value to V=200.
4. Press the Chan-UP button to enter the service mode.
NOTE: The Tilt control moves all the way counter-clockwise as soon as the service mode is
entered and is considered normal. Chipper Check will set Tilt at 50% as soon as DTV306 is
selected.