THOMAS DÖRR TD 3000L M14, Руководство по эксплуатации

Страница: 8 / 18

Page 8 of 18
4.3 Start up and operation of the cutlery polishing machine
CAUTION!

Never install or operate the machine with a damaged power cord.

By suspicion of damage, for example an electrical fault smell, disconnect the machine from the power circuit
immediately and contact the Dörr-service personal.

Make sure the power cable is never placed near a hot surface.

Make sure the power cable is never pinched or brushed along a sharp edge or surface.

Never expose the machine to gushes or jets of water.
1. Remove the transportation safety device.(see chapter 3.5).
2. Plug the power plug into a regulated power outlet (220/230V).
3. Fill the complete contents of the original Dörr polishing granulate Type SG 3000L into the polishing bin of the
machine.
4. Place the cutlery basket directly underneath the ejection opening of the machine
5.
Turn on the machine by switching to “I” on the rockerswitch..
The heating process will start automatically.
6. The readiness for operation is indicated after 30 min by the green LED. The wet cutlery can now be inserted
into the feed chute.
7. After use, let the machine run for about 20 minutes so the wet granulate can dry.
Depending on the amount of operating hours, replace granulate within 4-8 weeks (approx. 200 Hours). (See
chapter 5.2 Replacing the granulate)
The best polishing results can be achieved by inserting wet cutlery either straight from the dishwasher or a
water bath.
Already dried water spots (lime residue) cannot be removed by the cutlery polisher.
Insert one hand full of cutlery (approx. 10 pieces) into the feed chute every 10 seconds to get the most
capacity out of the cutlery polisher.
4.4 Further safety references
CAUTION!
Crushing can occur if the top cover falls down

Always open the top cover till the limit stop till the mounted gasprop is fully extended
Wrong way Right way
CAUTION!
Fingers can be pinched between the ejection opening and the frame

Never stick fingers in between the ejection opening or feed chute and the frame because the
machine vibrates during operation which causes the bin to sway back and forth
Danger zone