Page 13 of 18
Continued on the following page
Malfunction /
Problem
Possible causes
Solution
Machine does not
start
1.
2.
3.
4.
Top cover is not
closed.
Damaged Fuse.
Power plug may
not be plugged in.
Machine has a
malfunction.
1.
2.
3.
4.
Close the top cover.
Check the fuses and have them replaced by an
authorized service technician.
Check if the power plug is inserted correctly.
Contact an authorized service technician.
A cutlery jam has
occurred inside the
machine.
1.
2.
Too much cutlery
has been placed
into the machine.
The granules
have swollen,
caused from
absorbing too
much moisture.
1.
2.
Begin feeding the machine with 30-40 cutlery
pieces. Afterwards only place a hand full of
cutlery inside the machine after the previous fed
cutlery has vanished underneath the granules.
In case the granules have absorbed too much
moisture, it will swell causing each corn to
expand. The filling volume will expand by
approximately 20-30%. This means the openings
for the cutlery pieces become smaller. To avoid
this happening we strongly recommend
performing the heating up and final drying
process. Please change the granules immediately
if this is the case. (See page 9, chapter 5.2)
The cutlery is
abnormally
intensively scratched.
1. The cutlery
pieces fall too
deep from the
ejection chute.
1. Please immediately make sure the cutlery basket,
in which the cutlery pieces fall into, is placed
directly underneath the ejection chute.
Содержание TD 3000L M14
Страница 18: ...Page 18 of 18...