Thetford SHB981 Series, Руководство пользователя и инструкция по установке

Страница: 19 / 22

19
INSTALLATION
Fault Indication
Error or Fault codes in the Induction system are displayed on the LED display by
flashing ‘E’ or ‘┌┘’ symbol, followed by a number. In the event that the induction
unit detects an error or internal fault other than ‘H’ residual heat, contact the
Thetford Service Centre.
SERVICING
Do not modify this appliance. All servicing must be carried out by an approved
competent person. Before any service work is started the appliance should have
been left to cool and be disconnected from both the gas and electrical supplies.
After any service or maintenance work the appliance must be checked for both
electrical safety and gas soundness.
Thetford Ltd does not accept responsibility for loss or injury caused directly or
indirectly by incorrect use of this appliance. In accordance with our policy of
product development we reserve the right to amend designs and specifications
without prior notice.
If servicing requires removal of the appliance.
To remove the hob
(1) Isolate the mains electricity supply and disconnect appliance from the supply.
(2) Turn off the gas and disconnect the appliance from the gas supply.
(3) Disconnect the appliance from the 12V DC electricity supply.
(3) Release and remove the appliance clamping screws.
(4) Carefully lift out the appliance from the worktop and place on a suitably
protected surface.
Hob burner gas valve removal/replacement
Shut off the gas supply and disconnect the gas and electrical supplies from the
unit. Remove the hob from the worktop as above.
Remove the appropriate control knob by pulling up on the knob.
From underside of hob, unclip and remove the spark generator from the side of
the rear cover. Remove the 5 fixing screws and lift the rear cover aside. Carefully
disconnect the appropriate thermocouple at the gas valve. Unscrew the
appropriate gas supply pipe nut.
Remove the appropriate gas valve clamp by unscrewing the two screws.
Withdraw the gas valve from the underside of the hob. The circular ignition switch
actuator is a spilt collet which can be removed from the tap spindle and the tap
may then be detached from the appliance.
Replace the valve and gasket. Refit using the reverse of the above procedure.