Thetford SHB981 Series, Руководство пользователя и инструкция по установке

Страница: 14 / 22

14
INSTALLATION
Regulations and Standards
In the interest of safety, it is a legal requirement that all gas and electrical
appliances are only installed and serviced by an approved competent person, in
accordance with the local and National standards in force. Failure to install the
appliance correctly will invalidate any warranty or liability claims and may lead to
prosecution. Particular attention shall be given to the requirements regarding
ventilation in AS/NZS 5601.2 “LP Gas installations in caravans and boats for
non-propulsive purposes”. Read the Installation and User Instructions and
warnings before installing or using this appliance.
A gas dispersal hole is recommended beneath the appliance, venting to the
outside, with minimum size Ø12mm, maximum Ø25mm, which should be
screened and baffled to prevent direct draughts to the appliance, see Fig 4.
Air vents and gas dispersal holes must be kept clear.
The manufacturer cannot accept responsibility for failure in performance if the
appliance is not installed in accordance with these instructions.
Fig. 3 Fixing the Hob into the Worktop Cut-out
1. Locate the four lengths of threaded stud, four washers and wing
nuts.
2. Screw the four threaded studs into the threaded fixings to the
underside perimeter of the hob.
3. Position appliance in worktop and attach washers & wing nuts to
the threaded studs, checking the position of the hob in worktop and
perimeter seal before tightening the wing nuts.
To ensure correct operation this appliance must be mounted into a worktop cut-
out above a self-contained cabinet which is not connected to externally vented
chambers in adjacent furniture, other than a correctly sized gas dispersal hole as
described above. Any holes for cables and pipes must have the minimum
clearances.