Thermopatch NL-15 R/SQR MAMMOTH, Руководство пользователя

Страница: 17 / 39

thermopatch.com
17
8. Maintenance instructions
8.1 Daily maintenance
Clean the outside of the machine regularly with a clean, moist cloth. First switch off the
machine, let it cool down and pull the plug out of the socket.
Every now and then the inner parts of the press should also be cleaned from dust and lint.
•
First switch off the current before performing this operation and remove the bottom
plate.
For good press results it is important to keep the press surfaces clean. Therefore, clean the
teflon coating of the upper platen with a clean, dry cloth.
•
Do not touch the heating element!
Also clean the silicone rubber of the press platen daily with a dry cloth. Do not use solvents
or other chemical substances to remove impurities. Do not let buttons, zips, etc. come
between the plates. In this way, the silicone rubber will remain intact for a long time.
8.2 Periodic maintenance
The mechanism of the NL-15 R / SQR needs no maintenance.
Remove collected moisture from the separator of the air filter regulator at least once a
week.
The rubber pads and the upper plate must be cleaned once or several times daily. Clean
them with a clean and dry cloth when they have cooled down. They must be absolutely
smooth and clean.
Both the and the lower press pad should be replaced regularly.
Remove the old sealing cushion and carefully remove all glue residues from the metal
surface. The surface must be absolutely clean and smooth, so that the new rubber cushion
has an optimal adhesion to the metal platen
Teflon replacement
In order to be able to replace the teflon of the upper platen, the press needs to be warmed
up until 80 °C. Remove the worn teflon sheet and remove glue residue carefully from the
metal surface by using a scraper or a putty knife.
After this, brush the surface with with a copper wire brush. Finally clean the upper platen
with a soft cloth. The newly applied teflon will stick best when the surface is completely
clean.
Make sure no air is trapped in underneatch the teflon cover.
8.3 Parts for regular replacement for maintenance:
• Sealing pads Art.nr.
for type R: 160 mm round SPAMA-01-04
for type SQR: 140 x 140 mm SPAMA-01-04 VA
• Self adhesive teflon sheet
for type R: 160 mm, round SPAMA-03-21
for type SQR: 150 x 150 mm SPAMA-03-21 V
• Fuse
4 A TR SPAMA-04-10