Thermopatch NL-15 R/SQR MAMMOTH, Руководство пользователя

Страница: 12 / 39

thermopatch.com
12
6.5.3 Time settings
The default sealing time setting of the NL-15 R / SQR is 12 seconds. Adjusting the settings
can be done with the control panel.
Change time
Push the time button once. Change the time setting in steps of 1 second by pushing the - or
+ button. The range is 1 - 60 seconds.
6.5.4 Power save
When you want the machine to switch to a lower energy level when you are not working,
you can use the power save mode.
Push the time button twice.
Set the power save mode in steps of 1 minute by pushing the + or – button.
Power save ranges from 1-60 minutes.
If it is set to 0 the power save mode is not active and the machine will be heated
continuously.
6.5.5 Second sealing cycle
In some cases it is desirable to seal a second time.
Push the AUTO button during three seconds. A second seal cycle of 2 seconds takes place.
You can switch this option off by pushing the button for three seconds once more.
6.5.6 Interrupting the sealing cycle
There are various means to interrupt the sealing cycle of the machine. You can interrupt the
operation by:
• Pushing a button of the display randomly.
• Turning the on/off switch on the front.
• Stir the safety bar.
• Push the emergency stop button, pull it out and switch on the machine again.

ATTENTION!
When the first heat sealing cycle is interrupted, the second cycle will not start.