Thermopatch NL-15 R/SQR MAMMOTH, Руководство пользователя

Страница: 14 / 39

thermopatch.com
14
6.5.8 Messages in the display
A description is given below of the messages in the display which appear immediately after
turning on the machine.
Further, we will discuss some failure codes that can be displayed on the control panel display.
•
During heating up of the machine the temperature,
pressure and time are displayed.
• During the press cycle the press time is displayed from 0 to the programmed sealing
time
• Automatic mode ON/OFF is displayed with the Robot-icon( ).
• is displayed during POWER SAVE MODE.
Select the required preset
by pushing the + button.

ATTENTION!
When the first heat sealing cycle is interrupted, the second cycle will not start.
6.5.9 Error codes
There are 6 different failure codes that can be displayed; contact your Thermopatch sup -
plier.
01 Sensor defective or broken sensor cable
02 Sensor short cut
03 Element defective or broken element cable
04 Pressure set too low
05 Pressure set too high
06 Safety switch interrupted or defective
6.5.10 Preprogrammed settings
The setting of the heat sealing time and temperature is dependant on the labour that has to
be executed and the materials to be marked. These can be adjusted by the operator.
By pressing the “AUTO” button the NL-15 R/SQR can be entered into and taken out of op-
erational mode.
Only when the NL-15 R/SQR is taken out of oprational mode parameters can be altered and
presets can be chosen (nr. 1 - 5) by pressing the + button.
Presented in the display:
• the chosen preset:
See P1, P2, P3, P4, P5
• The temperature
• The set time: see preset in seconds
• Day counter: 001
• Machine in operational mode: Locked