Thermo Orion 410Aplus, Инструкция по эксплуатации

Страница: 9 / 131

pH mV Rel mV Conc
SETUP CALIBRATE
MEASURE
2nd
ready
bold
EXP
ON
OFF
°
C
ATC
SETUP:
READY
HOLD
BEEP
AUTOSHUTOFF
SLOPE
RESOLUTION
ISOPOINT
RESET
TIMER INTERVAL
REMAINING TIME
SET REAL TIME
SET DATE
HIGH ALARM LIMIT
LOW ALARM LIMIT
PRINT MODE: 1 = MAN, 2 = READY, 3 = TIMED
PRINT INTERVAL
DATA LOG MODE: 1 = MAN, 2 = READY, 3 = TIMED, 0 = OFF
DATA LOG INTERVAL
DOWNLOAD DATA
DATA CLEAR 1-1
1-2
1-3
1-4
2-1
2-2
2-3
2-4
3-1
3-2
3-3
3-4
4-H
4-L
5-1
5-2
6-1
6-2
6-3
6-4
See Manual for Error Codes.
power
yes
2nd
no
mode
cal
measure
print
setup
timer
Orion 710A+ advanced ISE/pH/mV/ORP
B. Orion 420Aplus and 710Aplus Set Up and Self-Test
NOTE : Use this procedure when the instrument
is first received and whenever troubleshooting
becomes necessary.
1. Connect BNC shorting cap (Orion 090045) supplied with meter to
sensing electrode input.
2. Disconnect the ATC probe.
3. Plug line adapter (Orion 020125 for 110V, Orion 020130 for 220V) into
an appropriate wall outlet then securely into meter power receptacle.
NOTE: Firmly push the power adapter into the jack on
the back of the meter.
4. Press and hold yes while pressing power . The instrument automatically
performs electronic and hardware diagnostic tests. See the explanation
in the Self-Test Section of the troubleshooting guide for a more
detailed explanation.
a. When “O” appears in the lower field, press each key one at
a time including power . A numeric digit will be displayed
for each keypress.
b. During TEST 8, the meter will turn off, then back on.
c. After completion of the self-test, proceed to the
Check-Out Procedure.
Orion Benchtop pH/ISE Meter Instruction Manual
Set Up Self-Test and Check-Out 5
Figure #2 Front Panel Orion 710Aplus