Thermo 3010 Series, Руководство по эксплуатации и техническому обслуживанию, Страница: 9 / 37

Model 3010 Incubator ________________________________________________________Installation and Start-Up
1 - 4
6. Remove and save the two screws from the back of the
control panel on the bottom unit as shown in Figure 1-8.
7. Insert the stacking brackets into the slots on the rear of
the control panel of the bottom unit (Figure 1-5). Align
the slots in the brackets with the mounting holes on the
rear of the incubators. Secure the brackets with the
screws saved above and the 1/4-20 bolts provided in the
stacking kit. A 7/16” wrench or socket will be required
for the bolts.
8. Secure the base of the top unit to the exterior top of the
bottom unit by tightening the 5/16-18 stacking bolts
using a 1/2” (13mm) wrench or suitable tool.
9. Replace the base cover on the top unit.
10. The stacked units are ready to be placed into service.
c. Preliminary Cleaning and Disinfecting
1. Remove the protective plastic coating on the shelf sup-
ports and air duct, if present.
2. Using a suitable laboratory disinfectant, disinfect all
interior surfaces including shelves and shelf supports,
door gaskets, blower wheel and CO
2
sensor. Refer to
Section 5.1.
d. Installing the Access Port Filter
Locate the opening in the top left corner of the interior
chamber. Remove the tape from the opening on the outside of
the unit. Locate the stopper with filter in the hardware bag.
Install in the opening inside the chamber. See Figure 1-9.
e. Installing the Air Sample Filter
1. Remove the filter from the shipping bag.
2. Separate one section of the tubing from the filter. Install
this section to the fitting on the blower plate.
3. After installing the top duct, connect the filter assembly
to the tubing coming through the top duct.
4. Insert the free end of the air sample filter tubing into the
larger hole in the back of the blower scroll. See Figure
1-9 for completed configuration.
Figure 1-9